Mitutoyo - Individual Square Gage Blocks - Inch

Precision Gage Blocks are widely available in sets in various sizes. The nominal gage lengths of blocks are mathematically determined so that specific desired lengths can be obtained by combining selected blocks. Several tolerance grades are available per ASME B89.1.9‐2002 ( USA ). They are made to several different tolerance grades categorized as Master Blocks, Calibration Blocks, Inspection Blocks, and Workshop Blocks.

Master or Reference Blocks are used as basic reference standard
Calibration Blocks are used for calibrating inspection blocks and high precision gauging work. Grade
Inspection blocks are used as standards and for comparative gauging.
Workshop blocks are uses as gauges on the shop floor for a variety of direct measurement precision application.

Thread Check Inc offers an extensive selection of Mitutoyo gage blocks in various grades in a choice of rectangular or square, metric or inch, and steel or CERA ( ceramic ) types. Contact a Thread Check sales engineer for assistance with your requirements.

Wringing is the method of placing two gage blocks together. Wringing is accomplished by placing one block crosswise from another and then swiveling it parallel with pressure which causes the two blocks to adhere to each other creating a new length from the combined two sizes. Multiple gage blocks can be combined using this wringing process. It is best to use the least amount of gage blocks to achieve a desired length.

Square Gage Block - Steel - 0.020"